Command Mode
Interface configuration
Usage Guidelines
When authorization string checking is enabled, the FDDI module uses the current authorization string to verify SMT requests from remote stations. This command is only valid within FDDI module interface-configuration mode.
Example
This example shows how to enable authorization string checking.
hostname(config-if)# fddi authorization
This example shows how to disable authorization string checking.
hostname(config-if)# no fddi authorization
Related Commands
fddi (auth-string)
fddi (notify-timer)
fddi (novell-snap-translation)
fddi (unmatched-snap-translation)
interface
show (interfaces)
fddi (auth-string)
Use the fddi auth-string interface configuration command to assign a new authorization string value used in the verification of station management (SMT) requests. Use the no fddi auth-string command to clear the existing authorization string.
fddi auth-string string
no fddi auth-string
Syntax Description
string A string of 4 to 80 alphanumeric characters entered in multiples of 4 characters.
Default
No FDDI authorization string is set.
Command Mode
Interface configuration
Usage Guidelines
This command is only valid within FDDI module interface-configuration mode.
Note You must enter an authorization string with a number of characters (including punctuation and numbers) that is divisible by 4.
Example
This example shows how to assign the authorization string value check_it (8 characters).
hostname(config-if)# fddi auth-string check_it
Related Commands
fddi (authorization)
fddi (notify-timer)
fddi (novell-snap-translation)
fddi (unmatched-snap-translation)
interface
show (interfaces)
fddi (notify-timer)
Use the fddi notify-timer interface configuration command to assign a new timer value for the Neighbor Notification Protocol. Use the no fddi notify-timer command to set the timer value to module defaults.
fddi notify-timer seconds
no fddi notify-timer
Syntax Description
seconds A number between 2 and 30 seconds.
推荐阅读
- 交换机与路由器,网速慢
- 如何理解网络交换机的原理
- 思科Catalyst 2900系列XL 10/100交换机
- 上 交换技术攻略:网络交换机配置技巧
- 思科3500系列交换机的基本配置命令
- Cisco MDS 9000 系列交换阵列管理
- 交换机端口镜像配置
- 2 交换机VLAN的配置
- 图解分析交换机与路由器组网功能
- 通过Web浏览器修改交换机各种参数