slot-number/interface-port-number
Displays status information about a specific type of interface (for
example, serial) on a VIP2 or VIP4 in a Cisco 7000 series or Cisco
7500 series router
Router# show interfaces serial 3/1/0
show protocols
Displays protocols configured for the entire system and for specific
interfaces
show running-config
Displays the running configuration file
show startup-config
Displays the configuration stored in NVRAM
5. show Cisco 7200 Series and Cisco uBR7200 Series Routers
下列显示72的SHOW结果！
Following is an example of the show interfaces serial port-adapter-
slot-number/port-number:channel-group command for Cisco 7200 series
and Cisco uBR7200 series routers. It shows all of the information
specific to the first multichannel E1/PRI port (port 0) in port
adapter slot 2, channel group 1:
Router# show interfaces serial 2/0:1
Serial2/0:1 is up, line protocol is up (looped)
Hardware is Multichannel E1
Internet address is 1.6.0.1/30
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load
1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input 00:00:07, output 00:00:07, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/64/0 (size/threshold/drops)
Conversations 0/1 (active/max active)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
87 packets input, 6521 bytes, 0 no buffer
Received 87 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
87 packets output, 6521 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
no alarm present
Timeslot(s) Used:1-31, subrate: 64Kb/s, transmit delay is 0 flags
推荐阅读
- Cisco路由器IOS映像恢复及升级方法
- Cisco 路由器 VPN典型配置
- MPLS交换路由器的设计与实现
- 路由器在网络地址转换中的应用
- 下一代IP网与第5代路由器
- 解决CISCO路由器Y2K的快捷方法——兼与梁伟文先生商榷
- 关键业务数据包优先发送及其在Cisco路由器中的实现
- HP的路由器和CISCO的路由器互联
- 使用路由器NAT功能接入INTERNET配置
- CISCO路由器产品配置手册二--PSDN