云南龙网

  1. 首页 > 云知道 > >

路由器的用户级别

云知道


Define an Enable PassWord for System Operators Examples
In the following example, you define an enable password for privilege level 10 for system operators and make clear and debug commands available to anyone with that privilege level enabled.
enable password level 10 pswd10
privilege exec level 10 clear line
privilege exec level 10 debug ppp chap
privilege exec level 10 debug ppp error
privilege exec level 10 debug ppp negotiation
The following example lowers the privilege level of the show running-config command and most configuration commands to operator level so that the configuration can be viewed by an operator. It leaves the privilege level of the configure command at 15. Individual configuration commands are displayed in the show running-config output only if the privilege level for a command has been lowered to 10. Users are allowed to see only those commands that have a privilege level less than or equal to their current privilege level.
enable password level 15 pswd15
privilege exec level 15 configure
enable password level 10 pswd10
privilege exec level 10 show running-config
Disable a Privilege Level Example
In the following example, the show ip route command is set to privilege level 15. To keep all show ip and show commands from also being set to privilege level 15, these commands are specified to be privilege level 1.
privilege exec level 15 show ip route
privilege exec level 1 show ip
privilege exec level 1 show

    推荐阅读


    上一篇：昆虫备忘录蚂蚱为什么叫挂大扁儿

    下一篇：节约粮食的好处