Cisco 和 Intel 动态路由的连接


对于不同厂商路由器的对连,因为其具体功能实现方式的不同,在配置上存在一定,以Cisco与Intel的路由器为例,拓扑图如下:
DDN连接(rip)
Intel 9100的设置
Basic
WAN1:Leased Line PPP
WAN2:Unused
Next
Bandrate(bps):64K 根据用户实际情况
Link Name: Test-Link1 用户自己定义
Next
IP Routing:RIP-1
IPX Routing: Disabled
WAN Bridging:Disabled
Next
IP Address:10.1.0.1
NetworkMask:255.255.255.0
Protocol:RIP-1
Router Name:intel9100 用户自己定义
Finished
将治理PC的IP与Router设在同样网段上,如:10.1.0.20 。Restart治理PC 。再次 打开DeviceView.Open 10.1.0.1(intel9100). 在Configuration下选择 Save to FlashPROM 。
Device Setup
Advanced
Link...
选择test-link1(在Basic设置) 。然后Setup...
WAN Protocol:PPP over HDLC
DataCompression:Disabled
OK
Protocals...
IP...
选择test-link1, 然后选择Setup...
Routing Protocal:RIP-1
Numbered:Yes
IP Address: 10.30.0.1
Network Mask: 255.255.255.0
OK
...
OK
Exit...
Exit(Savedata)
在Configuration下选择 Save to FlashPROM 。
Cisco2501的配置
version 11.0
service udp-small-servers
service tcp-small-servers
!
hostname Bluegarden
!
enable secret 5 $1$DLbm$E8bBQWDaqsoVxAqRtaMxm1
enable passWord bluegarden
!
!
interface Ethernet0
ip address 20.1.0.1 255.255.255.0
!
interface Serial0
ip address 10.30.0.2 255.255.255.0
encapsulation ppp
no fair-queue
!
interface Serial1
no ip address
shutdown
!
router rip
network 20.1.0.0 255.255.255.0
network 10.30.0.0 255.255.255.0
!
!
line con 0
line aux 0
transport input all
line vty 0 4
password bluegarden
login
!
end

    推荐阅读